Kleenguard 41506 Disposable Coveralls Xl 25-pack

Product Description

The KLEENGUARD 41506 is a disposable hooded coverall designed for liquid and particle protection in surface prep, painting, and similar light industrial applications. Built from microporous film laminate, the garment blocks liquid splash and airborne particulates while remaining lightweight enough for extended wear. The front zipper closure is water-resistant, and elastic wrists and ankles (EWA) seal the suit at the openings to reduce contamination entry. Serged seams run throughout the garment for durability. These coveralls ship 25 per case and are suited for painters, maintenance technicians, and industrial workers who need single-use protective outerwear.

The 41506 falls within the KLEENGUARD A45 series, targeting surface preparation and spray painting environments where liquid overspray and fine particle contamination are the primary hazards. The X-Large size accommodates a range of body types for a comfortable fit during active work. Because these are disposable single-use garments, they are well suited for job sites, spray booths, maintenance shutdown events, and any scenario where cross-contamination control or post-task disposal is preferred over laundering reusable gear.

Key Features

• Microporous film laminate construction provides liquid splash and particle barrier protection
• Water-resistant front zipper closure for reliable sealing during use
• Elastic wrists and ankles (EWA) seal garment openings against contamination entry
• Attached hood included for full head and neck coverage
• Serged seams throughout for added garment integrity
• Single-use disposable design — no laundering required; 25 garments per case
• Meets NFPA 99 standard for non-hazardous protection applications

Compatibility

Designed for use in non-cleanroom, non-hazardous environments requiring liquid and particle protection, including surface preparation, spray painting, and general light industrial maintenance tasks.

Installation Notes

Disposable coveralls are donned and doffed by workers — no installation tools required. Inspect each garment for tears or defects before use and discard any damaged units. Follow your facility or job-site PPE protocol for proper donning sequence, including respiratory and eye protection where required. Dispose of used garments according to applicable local waste disposal regulations; do not reuse after contamination exposure.