Kennametal 6771074 Replaceable Drill Tip 6mm 180 Deg KCP15A

Product Description

The KENNAMETAL 6771074 is a replaceable drill tip designed for use with compatible KenTip FS modular drilling systems. It carries the ISO designation KTFSS06000FEGM and features a 6.00 mm cutting diameter with a 180-degree flat point geometry. The tip is manufactured from fine-grain solid carbide in grade KCP15A and receives a PVD-applied AlTiN coating for thermal resistance and extended tool life in demanding cutting environments. The FEG insert geometry and straight flute configuration support chip evacuation in a range of hole-making operations. This tip is sized to fit an Insert Seat Size A holder and weighs approximately 0.015 pounds.

This replaceable tip is suited for drilling operations in steel, stainless steel, and cast iron workpieces, covering ISO material codes P, M, and K. Typical applications include standard through-hole drilling as well as flat-bottom drilling, inclined entry drilling, inclined exit drilling, and counterboring. It is intended for use in CNC machining centers and automated drilling equipment where modular tooling systems allow rapid tip exchange without removing the holder from the spindle. The two-flute, four-margin, no-coolant-through design is appropriate for controlled-environment drilling at this diameter.

Key Features

• 6.00 mm cutting diameter with 180-degree flat point for flat-bottom and through-hole drilling
• Fine-grain solid carbide substrate in manufacturer grade KCP15A for wear resistance
• PVD AlTiN coating provides thermal protection during dry or minimal-lubrication cutting
• FEG insert geometry supports inclined entry, inclined exit, and counterboring applications
• Straight flute and two-flute, four-margin design for stability at small diameters
• Insert Seat Size A — matches compatible KTFSS series modular drill bodies

Compatibility

Designed as a replaceable tip for compatible KTFSS series modular drill holders accepting Insert Seat Size A. The ISO designation KTFSS06000FEGM identifies the holder series and seat interface. Verify holder seat size before ordering.

Installation Notes

Replaceable drill tips of this type are installed and removed by a licensed machinist or tooling technician using the appropriate clamping key or torque tool specified by the holder manufacturer. Power down and lock out the machine spindle before exchanging tips. Inspect the holder seat for chips, debris, or wear before seating the new tip, as contamination on the seating face will affect runout and tool life. Do not exceed the holder manufacturer's specified clamping torque for the seat size.