Kennametal 2465323 Indexable Face Mill 2 in 6 Flute

Product Description

The KENNAMETAL 2465323 is an indexable face mill designed for precision chamfering and face milling operations in metalworking applications. Built around the KSOM Mini series platform, this cutter accepts OF.T 06L5 inserts held in place by a wedge clamping system. It features a 2.0 inch minimum cutting diameter with a maximum cutting diameter of 2.35 inches and a maximum depth of cut of 3.5 mm (0.138 inches). With 6 flutes and a right-hand cutting direction, the 2465323 delivers consistent material removal on ferrous and non-ferrous workpieces. Licensed machinists and tooling specialists install and configure this cutter for CNC machining centers and manual milling equipment.

This face mill is suited for production and job-shop milling environments where controlled chamfer angles and face finishing are required. The 43-degree chamfer angle geometry targets beveling and face preparation work on steel, cast iron, and similar materials. The 3/4 inch arbor hole fits standard machine spindle tooling common in vertical and horizontal machining centers. The KSOM Mini series is engineered for smaller-diameter indexable milling where a compact, rigid cutter body is needed without sacrificing insert count or surface finish quality.

Key Features

• KSOM Mini series cutter body with wedge-style insert retention for secure clamping under load
• Accepts OF.T 06L5 inserts - replacement inserts sourced separately
• Six-flute configuration supports higher feed rates and improved surface finish
• Right-hand cutting direction compatible with standard CNC spindle rotation
• Maximum spindle speed rated to 12,530 RPM for high-productivity runs
• No coolant-through design simplifies setup on standard machine tooling

Compatibility

Designed for use with OF.T 06L5 inserts in KSOM Mini series tooling setups. Compatible with machine spindles accepting a 3/4 inch arbor hole. Confirm machine spindle taper and arbor toolholder specifications before installation.

Installation Notes

Installation and tool changes should be performed by a qualified machinist with the machine spindle fully stopped and the machine in a locked-out, de-energized state per facility lockout/tagout procedures. Torque the arbor fastener according to the machine toolholder manufacturer specifications - do not estimate. Inspect inserts for wear or chipping before each setup and replace as needed using the correct torx or hex key specified by KENNAMETAL for this cutter body. Verify runout with a dial indicator after mounting before beginning a cut.