Jmf Company 2546016161200 Wrot Copper Reducing Tee

Product Description

The JMF COMPANY 2546016161200 is a wrot copper reducing tee fitting designed for sweat (CxCxC) connections in plumbing and refrigeration piping systems. Manufactured from C12200 copper alloy and produced to ASTM B75 material specifications, this fitting meets the dimensional and pressure requirements of ASME B16.22 and MSS SP-104. The nominal size is 1 inches x 1 inches x 3/4 inches, with refrigeration outer diameters of 1-1/8 inches x 1-1/8 inches x 7/8 inches. All three ports use female soldered end connections. Wrot construction means the fitting is formed from wrought copper rather than cast, resulting in consistent wall thickness and a smooth interior bore suited for high-integrity brazed or soldered joints.

This reducing tee is rated for residential, commercial, and industrial applications including potable plumbing distribution, hydronic systems, and refrigeration piping. The 3/4-inch branch outlet makes it a practical choice when a main run must supply a reduced-diameter branch line without additional adapters. Licensed plumbers and refrigeration technicians install this fitting wherever a tee-off with a size reduction is required at a single junction point, keeping the joint count low and the system layout clean.

Key Features

• C12200 phosphorus-deoxidized copper alloy construction for reliable soldered and brazed joints
• Wrot process delivers consistent wall thickness and smooth internal surface
• CxCxC female soldered end connections on all three ports
• Meets ASME B16.22 and MSS SP-104 dimensional standards
• Manufactured to ASTM B75 material specification
• Suitable for plumbing, refrigeration, residential, commercial, and industrial service

Compatibility

Designed as an OEM-style wrot copper sweat fitting compatible with standard copper tubing systems conforming to ASME B16.22 and MSS SP-104 for plumbing and refrigeration applications.

Installation Notes

Installation is performed by a licensed plumber or refrigeration technician. Shut off and depressurize the system and drain any remaining fluid before cutting into an existing line. Clean and flux all mating tube ends and fitting sockets thoroughly before applying heat; follow applicable IPC and IFGC code requirements for solder or brazing alloy selection based on the service fluid. Never apply flux or heat to a pressurized line.