Jmf Company 2546016121600 Wrot Copper Reducing Tee

Product Description

The JMF COMPANY 2546016121600 is a wrot copper reducing tee fitting used in plumbing and refrigeration piping systems. It connects three lines in a tee configuration with a reduced branch, allowing a 3/4-inch outlet off a 1-inch run. All three ends use female solder (sweat) connections for secure, leak-resistant joints. The fitting is manufactured from C12200 copper alloy to ASTM B75 material specification and meets ASME B16.22 and MSS SP-104 dimensional standards. Licensed plumbers and refrigeration technicians install this fitting in copper pipe systems where branch sizing must step down from the main run diameter.

This reducing tee is rated for residential, commercial, and industrial applications including potable water distribution, hydronic heating, and refrigeration systems. The nominal size is 1 inch x 3/4 inch x 1 inch, with refrigeration outer diameters of 1-1/8 inches x 7/8 inch x 1-1/8 inches. Its wrot construction means it is formed from wrought copper rather than cast, producing a denser grain structure and consistent wall thickness suited for pressure service across all three connection points.

Key Features

• Reducing tee configuration: 1 inch x 3/4 inch x 1 inch nominal, allowing branch size reduction without an additional fitting
• All female solder (C x C x C) end connections for standard sweat joining
• C12200 copper alloy construction per ASTM B75 material specification
• Wrot process delivers uniform wall thickness and higher-density grain structure
• Meets ASME B16.22 and MSS SP-104 applicable standards
• Suitable for plumbing, refrigeration, residential, commercial, and industrial systems

Compatibility

Designed for use in copper piping systems requiring a 1 inch x 3/4 inch x 1 inch reducing tee with female solder connections, conforming to ASME B16.22 and MSS SP-104 dimensional standards for wrot copper fittings.

Installation Notes

Installation should be performed by a licensed plumber or refrigeration technician in accordance with applicable local plumbing codes and ASME standards. Shut off and depressurize the system completely before cutting into any existing line. Clean and flux all pipe ends and fitting cups thoroughly before applying heat, and use lead-free solder where potable water service is involved. Avoid overheating the fitting during soldering, as excessive heat can compromise the joint integrity of adjacent connections on the tee.