Jmf Company 2525412129800 Wrot Copper 90 Degree Street Elbow

Product Description

The JMF COMPANY 2525412129800 is a wrot copper 90-degree close rough street elbow used in pressure-rated copper piping systems. It features a male soldered (FTG) inlet and a female soldered (C) outlet, both sized at 3/4 inch. Manufactured from C12200 phosphorus-deoxidized copper to ASTM B75, this fitting is suited for sweat-soldered assemblies in plumbing, HVAC, and refrigeration piping. The close rough configuration minimizes installed length, making it a practical choice in tight spaces where a standard radius elbow will not fit.

This street elbow is appropriate for residential, commercial, and industrial applications including domestic water distribution, hydronic heating, and refrigeration line sets. The FTG end accepts a copper tube end directly, eliminating one coupling where space or material cost is a factor. Its 7/8-inch outer diameter on the refrigeration side aligns with standard 3/4-inch ACR tube sizing. It is installed by licensed plumbers and HVAC-R technicians wherever a 90-degree direction change is required in a sweat-soldered copper system.

Key Features

• 90-degree close rough street configuration reduces installed fitting length
• FTG x C end connections allow direct tube-to-fitting assembly without an additional coupling
• C12200 wrot copper construction meets ASTM B75 material requirements
• Conforms to ASME/ANSI B16.22 and MSS SP-104 dimensional and pressure standards
• Rated for plumbing and refrigeration service in residential, commercial, and industrial systems

Compatibility

Designed for use in commercial, residential, and industrial plumbing and refrigeration systems requiring ASME/ANSI B16.22 and MSS SP-104 compliant wrot copper pressure fittings in 3/4-inch sweat-solder connections.

Installation Notes

Installation is performed by a licensed plumber or HVAC-R technician in accordance with the applicable IPC or IMC provisions. Shut off and depressurize the water or refrigerant system and allow all piping to cool completely before cutting and fitting. Tube ends must be cut square, deburred, and cleaned, and both mating surfaces must be properly fluxed before applying heat with a torch. Avoid overheating the fitting, as excessive heat can oxidize the copper and compromise the solder joint integrity.