Jeffrey Alexander 885-128SN Cabinet Bar Pull Satin Nickel

Product Description

The JEFFREY ALEXANDER 885-128SN is a cabinet bar pull finished in satin nickel, designed for residential and light commercial cabinetry applications. Part of the Hayworth Collection, this pull measures 6 inches in overall length with a 128 mm (approximately 5.04 inches) center-to-center hole spacing. The satin nickel finish provides a brushed, low-sheen appearance suited to contemporary and transitional cabinet hardware installations. Licensed cabinetry installers, finish carpenters, and experienced DIYers typically install this hardware as part of a kitchen, bath, or furniture refresh.

This bar pull fits standard cabinet doors and drawer fronts where a 128 mm center-to-center boring pattern is used. The Hayworth Collection offers a coordinated line of pulls and knobs, making it straightforward to maintain a consistent hardware profile across a full cabinet run. At 6 inches in overall length, the pull suits medium to large drawer fronts and full overlay door applications commonly found in residential kitchens and bathrooms.

Key Features

• Satin nickel finish delivers a brushed, understated appearance with corrosion resistance suitable for kitchen and bath environments
• 128 mm center-to-center spacing matches the most common standard boring pattern for cabinet hardware
• 6-inch overall length provides a substantial grip span for drawers and doors
• 7/16-inch width keeps the profile slim and unobtrusive
• 1-3/8-inch projection clears drawer fronts and door stiles cleanly without excessive overhang
• Part of the Hayworth Collection for easy coordination with matching hardware pieces

Compatibility

Designed as a direct-fit replacement or upgrade pull for any cabinet door or drawer front with a 128 mm center-to-center hole pattern. Compatible with standard machine screw mounting hardware typically included with the pull.

Installation Notes

Installation is performed by cabinetry installers, carpenters, or knowledgeable DIYers using a drill, appropriate bit, and a screwdriver or driver bit. Confirm the cabinet door or drawer front is pre-bored at 128 mm center-to-center before installation, or use a cabinet hardware jig to locate new holes accurately. Mounting screws should be tightened snugly without over-torquing to avoid cracking the cabinet face or stripping the screw hole. No power disconnection is required for this hardware installation.