Jeffrey Alexander 867-3DBAC Cabinet Pull Brushed Oil Rubbed Bronze

Product Description

The JEFFREY ALEXANDER 867-3DBAC is a rectangular cabinet pull finished in Brushed Oil Rubbed Bronze, part of the Anwick Collection. It measures 4.3125 inches in overall length with a 3-inch center-to-center hole spacing, making it a standard fit for a wide range of cabinet and drawer applications. The pull projects 1.0625 inches from the mounting surface and measures 0.625 inches in width. Licensed tradespeople and finish carpenters typically specify this hardware for kitchen cabinetry, bathroom vanities, and furniture installations where a warm, muted bronze tone is specified.

The 867-3DBAC suits residential cabinet installations in kitchens, bathrooms, laundry rooms, and built-in furniture. Its rectangular profile and Brushed Oil Rubbed Bronze finish make it a practical match for transitional and traditional design applications. The 3-inch center-to-center spacing is among the most common bore spacings in residential cabinetry, allowing straightforward replacement or upgrade of existing hardware without new drilling in many cases.

Key Features

• 3-inch center-to-center hole spacing for standard cabinet drawer and door compatibility
• 4.3125-inch overall length with a low-profile 0.625-inch width
• 1.0625-inch projection from the mounting surface
• Brushed Oil Rubbed Bronze finish for a warm, muted appearance
• Part of the coordinated Anwick Collection for consistent hardware specification across a project

Compatibility

Designed as a direct-fit replacement or new-install pull for residential and light commercial cabinetry with 3-inch center-to-center boring. Coordinates with other hardware in the JEFFREY ALEXANDER Anwick Collection.

Installation Notes

Installation is typically performed by a cabinetmaker, finish carpenter, or knowledgeable DIYer using a drill, template, and screwdriver. Verify cabinet door and drawer face thickness before selecting screw length, as mounting screws are not always included. Pre-drill pilot holes using a hardware template to ensure accurate center-to-center spacing. Avoid over-tightening mounting screws, which can crack drawer faces or strip the threaded insert.