Jeffrey Alexander 530SN Cabinet Bar Pull Satin Nickel

Product Description

The JEFFREY ALEXANDER 530SN is a steel cabinet bar pull finished in satin nickel, part of the Key West collection. With an overall length of 20-7/8 inches and a diameter of 9/16 inches, this pull is sized for large cabinet doors and drawer fronts where a substantial, full-length grip is needed. The 480 mm center-to-center hole spacing makes it a direct fit for cabinetry pre-drilled to that standard. Cabinetmakers, finish carpenters, and kitchen and bath installers typically specify this pull for residential and light commercial millwork projects requiring a clean, brushed nickel aesthetic.

The 530SN is suited for kitchen cabinetry, bathroom vanities, built-in storage, and furniture applications where an elongated bar pull profile is appropriate. The Key West collection offers a transitional design that works across contemporary and traditional cabinet styles. The satin nickel finish coordinates well with brushed metal hardware and fixtures commonly found in residential interiors. At 480 mm center-to-center, this pull is intended for wider cabinet panels such as pantry doors, large drawer fronts, or appliance panels.

Key Features

• 480 mm (approximately 18-7/8 inches) center-to-center hole spacing for large cabinet applications
• 20-7/8 inch overall length with a 9/16 inch diameter bar profile
• 1-7/16 inch projection from the cabinet surface
• Satin nickel finish for a brushed, low-sheen appearance
• Steel construction for structural durability under repeated use
• Part of the Key West collection for coordinated hardware specification

Compatibility

Designed as a direct-mount cabinet bar pull for cabinetry with 480 mm center-to-center pre-drilled hole spacing. Suitable for kitchen, bath, and furniture applications requiring a large-format bar pull in satin nickel.

Installation Notes

Installation is typically performed by a cabinetmaker, carpenter, or finish installer using a screwdriver or drill driver. Verify cabinet face frame or door thickness before selecting fastener length, as machine screws must engage fully without over-penetrating. Pre-drill pilot holes to the 480 mm center-to-center dimension to prevent wood splitting on finished cabinet surfaces. Do not overtighten fasteners, as excess torque can crack face frames or strip mounting holes.