Jeffrey Alexander 484-396SBZ Cabinet Pinch Pull Satin Bronze

Product Description

The JEFFREY ALEXANDER 484-396SBZ is a cabinet pinch pull finished in satin bronze, designed for installation on cabinet doors and drawers in residential and light commercial cabinetry projects. Part of the Elara collection, this pull features a dual-tapped mounting hole configuration that accepts both 3-inch and 96 mm center-to-center spacing, giving installers flexibility without requiring separate hardware. At 4.5625 inches overall length and 0.5625 inches wide, it presents a clean, low-profile silhouette. Cabinetmakers, finish carpenters, and kitchen and bath installers commonly specify this pull for new builds and remodels alike.

The 484-396SBZ suits standard face-frame and frameless cabinet installations where a 3-inch or 96 mm hole spacing is required. The satin bronze finish integrates with warm-toned and transitional design schemes. Its compact width and modest projection of 0.9375 inches make it well-suited for overlay doors and drawer fronts where clearance is a consideration. No adapter plates or additional hardware are needed to accommodate both hole-spacing standards.

Key Features

• Dual-tapped holes accept both 3-inch and 96 mm center-to-center screw spacing
• Satin bronze finish from the Elara collection
• Overall length of 4.5625 inches with a low-profile 0.5625-inch width
• Projection of 0.9375 inches keeps clearance minimal at the cabinet face
• Pinch-pull profile suitable for doors and drawer fronts

Compatibility

Designed as a direct-fit replacement or new-installation pull for cabinets drilled at 3-inch or 96 mm center-to-center spacing, consistent with standard residential and light commercial cabinetry boring patterns.

Installation Notes

Cabinet pulls of this type are installed by finish carpenters or cabinetmakers using a drill template to ensure accurate hole placement. Power down any motorized cabinetry or integrated lighting before beginning work. Use the provided or appropriately sized machine screws and do not overtighten, as doing so may crack thinner door materials. Confirm center-to-center spacing matches existing boring before ordering multiples for a full project.