Jeffrey Alexander 484-32BNBDL Cabinet Pinch Pull Brushed Pewter

Product Description

The JEFFREY ALEXANDER 484-32BNBDL is a cabinet pinch pull finished in Brushed Pewter, part of the Elara Collection. It features a 32 mm center-to-center hole spacing and measures 2-1/16 inches in overall length. The pull has a width of 9/16 inches and a projection of 15/16 inches. Designed for cabinetry hardware replacement or new installation, this pinch pull suits kitchen cabinets, bathroom vanities, and furniture drawers. Cabinetmakers, finish carpenters, and general contractors commonly specify this hardware during millwork and cabinet installation projects.

This pinch pull is suited for residential and light commercial cabinetry applications where a clean, low-profile pull is specified. The Brushed Pewter finish coordinates with a range of cabinet finishes and hardware styles. The 32 mm hole spacing is a standard dimension that fits most pre-drilled cabinet doors and drawer fronts without modification. It is appropriate for overlay and inset door styles where a compact pull profile is preferred.

Key Features

• 32 mm center-to-center hole spacing fits standard pre-drilled cabinet doors and drawer fronts
• Brushed Pewter finish provides a muted, low-sheen appearance suited to transitional and traditional interiors
• Compact 2-1/16 inch overall length and 9/16 inch width for a low-profile look
• 15/16 inch projection keeps fingers clear of the cabinet surface for comfortable grip
• Part of the coordinated Elara Collection for consistent hardware specification across a project

Compatibility

Designed as a direct-fit replacement or new installation pull for cabinet doors and drawer fronts pre-drilled at 32 mm center-to-center spacing.

Installation Notes

Installation is typically performed by a cabinetmaker, finish carpenter, or general contractor using a screwdriver or drill driver. Power down any adjacent under-cabinet lighting or electrical before drilling new holes. Verify hole spacing against existing boring before ordering multiples for a full cabinet run. Use manufacturer-supplied or appropriately sized machine screws to secure the pull through the cabinet face.