Jeffrey Alexander 293-96NI Cabinet Pull Polished Nickel

Product Description

The JEFFREY ALEXANDER 293-96NI is a square bar cabinet pull from the Zane Collection, finished in polished nickel. It features a clean, angular profile suited to modern and transitional cabinetry in kitchens, bathrooms, and furniture applications. The pull measures 5-1/16 inches in overall length with a 96 mm center-to-center hole spacing, a 1/2 inch width, and a 1-1/4 inch projection from the mounting surface. Cabinetmakers, finish carpenters, and general contractors install this type of hardware during trim-out on both residential and light commercial projects.

This pull fits standard 96 mm bore spacing found on kitchen cabinets, bathroom vanities, built-ins, and furniture drawers. The polished nickel finish suits contemporary, transitional, and mid-century modern design schemes. It is part of the Zane Collection, which is built around a consistent square bar profile for a unified look across a full range of cabinet hardware.

Key Features

• 96 mm center-to-center hole spacing for direct fit on standard cabinet doors and drawer fronts
• Square bar profile with clean, angular geometry suited to modern and transitional interiors
• Polished nickel finish for a bright, reflective surface with broad design compatibility
• 5-1/16 inch overall length with a low 1-1/4 inch projection from the cabinet face
• Part of the Zane Collection for consistent hardware coordination across a full installation

Compatibility

Designed as a standard replacement or new-installation cabinet pull for cabinetry with 96 mm center-to-center bore spacing, including kitchen cabinets, bathroom vanities, and furniture drawer fronts.

Installation Notes

Cabinet pulls of this type are installed by cabinetmakers, carpenters, or finish trades using a screwdriver or drill driver. Mounting screws are typically sourced separately or supplied per manufacturer packaging; verify screw length against door or drawer front thickness before installation. Lay out all hardware locations before drilling to ensure consistent spacing across a run of cabinets. Handle polished nickel finishes with care to avoid surface scratching during installation.