Itm 715fl3632 Sds-plus Drill Bit 1.5 X 36 Inches

Product Description

The ITM 715fl3632 is an extra-long SDS-Plus rotary hammer drill bit designed for boring through concrete, brick, and stone in demanding construction environments. At 1.5 inches in diameter and 36 inches in length, it reaches depths that standard-length bits cannot. The carbide tip provides the hardness needed to penetrate dense masonry without premature wear. A deep fluted body channels dust and debris out of the bore hole continuously, reducing clogging and maintaining cutting efficiency throughout the hole. This bit is built for professional-grade use by electricians, plumbers, HVAC installers, and general contractors who need reliable penetration in hard substrates.

This bit is suited for residential and commercial construction applications where long-reach masonry drilling is required. Typical scenarios include core routing for conduit, pipe sleeves, or ductwork penetrations through concrete walls and block foundations. The SDS-Plus shank interface is the standard chuck system found on mid-size rotary hammer tools common across trade work. It performs in both rotary hammer and hammer-only modes depending on the host tool's capability.

Key Features

• 1.5-inch diameter carbide tip for aggressive masonry penetration
• 36-inch overall length for deep or through-wall drilling in thick substrates
• SDS-Plus shank fits standard rotary hammer chucks used across the trades
• Deep flute geometry removes debris continuously for cleaner, faster drilling
• Carbide tip construction resists wear when drilling concrete, brick, or stone

Compatibility

Designed for use with SDS-Plus rotary hammer tools; fits any tool equipped with a standard SDS-Plus chuck interface.

Installation Notes

Installation should be performed by a qualified tradesperson familiar with rotary hammer operation and applicable codes such as the NEC or IPC where penetrations affect fire-rated assemblies. Confirm the SDS-Plus bit is fully seated and locked in the chuck before operation. Always wear appropriate eye and respiratory protection when drilling masonry due to silica dust hazards. After drilling through a wall or floor penetration, seal and fire-stop the opening per local code requirements.