Irwin 5026001 Carbide-tipped Spiral Drill Bit 5/32 in

Product Description

The IRWIN 5026001 is a carbide-tipped regular spiral drill bit sized at 5/32 inch (0.1563 inch decimal) with a 3-inch overall length. The carbide tip is bonded to a high speed steel body, combining edge retention with toughness for demanding drilling applications. The 118-degree drill point angle is a standard general-purpose geometry suited to a wide range of materials. Right-hand cutting direction is standard for conventional drill press and hand-drill operation. This bit ships in a 5-piece quantity, making it practical for tool crib stocking or crew kits where small-diameter bits see frequent replacement.

This drill bit is suited for metal fabrication, mechanical contracting, electrical rough-in, and general trade work where a small-diameter carbide-tipped bit is needed. The 5/32-inch diameter is commonly used for pilot holes, sheet metal penetrations, and light structural drilling. It is appropriate for use in portable hand drills and bench-mounted drill presses. Electricians, plumbers, HVAC technicians, and general contractors will find this size useful for conduit, bracket, and hanger work.

Key Features

• Carbide-tipped cutting edge over high speed steel body for extended service life
• 5/32 inch diameter (0.1563 inch decimal) for precise small-diameter drilling
• 3-inch overall length fits standard chuck depths on hand drills and drill presses
• 118-degree drill point angle for general-purpose material entry
• Right-hand regular spiral for standard forward drilling operation
• Sold in a 5-piece quantity for stocking and crew use

Compatibility

Designed as a general-purpose replacement carbide-tipped spiral drill bit compatible with standard 3-jaw chucks accepting 5/32-inch shank diameters on corded and cordless hand drills and bench drill presses.

Installation Notes

Install and remove drill bits only when the drill is powered off and, for bench units, the power is disconnected. Secure the bit fully in the chuck and verify concentricity before operation to avoid bit walking or breakage. Carbide-tipped bits are brittle under lateral load — use steady, axial feed pressure and avoid flexing the bit. Follow applicable workplace safety standards for eye protection and chip management when drilling metal or hard materials.