Ironcube Works NL-5X350-100W 14 in White Nylon Cable Ties 100 Pack

Product Description

The IRONCUBE WORKS NL-5X350-100W is a 100-pack of 14-inch white nylon cable ties designed for wire bundling, cable management, and general fastening applications in electrical, HVAC, and low-voltage work. Each tie features a self-locking pawl mechanism that cinches down and holds without tools or additional hardware. Rated at 75 lb tensile strength, these ties hold bundled wire harnesses, conduit runs, and cable groups securely under normal service conditions. The white nylon construction resists moisture and provides a clean finish on visible installations. Ties measure 13.8 inches in usable length with a 0.19-inch strap width.

These cable ties are suited for residential and light commercial electrical work, HVAC wiring, panel rough-in, low-voltage cabling, and pool or irrigation control wiring. Electricians, HVAC technicians, and low-voltage installers use this size and tensile rating for standard wire bundle management throughout junction boxes, air handler cabinets, control panels, and conduit bundles. The 100-unit bagged pack keeps inventory organized on the job site or in a service vehicle.

Key Features

• 75 lb tensile strength suitable for standard wire bundle applications
• Self-locking mechanism cinches without additional tools or clips
• 13.8-inch usable length accommodates a range of bundle diameters
• 0.19-inch strap width for secure grip without excessive bulk
• White nylon construction resists moisture in typical indoor service environments
• 100-unit pack bagged for easy inventory and on-site use

Compatibility

Designed as a general-purpose cable tie for wire and cable management in electrical, HVAC, low-voltage, and plumbing control applications where a 14-inch, 75 lb self-locking nylon tie is specified.

Installation Notes

Cable ties are installed by electricians, HVAC technicians, and low-voltage professionals as part of wire management work governed by NEC and applicable local codes. De-energize circuits before bundling or re-routing conductors. Do not overtighten ties on insulated conductors in a way that deforms the jacket. Excess tail length should be trimmed flush after cinching to avoid sharp edges in the finished installation.