Ipex 500p4045dsch40elb Pvc Conduit 45 Deg Elbow Sch 40 5 in

Product Description

The IPEX 500p4045dsch40elb is a 5-inch trade size PVC conduit elbow designed for electrical raceway systems requiring a 45-degree change in direction. Built to Schedule 40 wall thickness standards, this standard-radius elbow features plain ends for solvent-weld connections to compatible Schedule 40 PVC conduit and fittings. With a 24-inch bend radius, it provides smooth wire pull transitions and reduces conductor stress during installation. Licensed electricians and electrical contractors install this fitting in both underground and above-grade conduit runs where code-compliant, corrosion-resistant raceway is required.

This elbow is suited for residential, commercial, and light industrial electrical conduit installations. It is commonly used in direct-buried runs, concrete-encased duct banks, and exposed indoor or outdoor applications where PVC conduit is permitted by the applicable electrical code. The plain-end design accepts standard PVC conduit cement and primer for a solvent-welded joint. Trade size 5 inches makes this fitting appropriate for large feeder and service-entrance conduit runs requiring a 45-degree directional change.

Key Features

• 5-inch trade size matches Schedule 40 PVC conduit for the same trade size
• 45-degree bend angle for standard directional changes in conduit routing
• 24-inch standard bend radius reduces pulling tension on conductors
• Schedule 40 wall thickness for strength in direct-buried and encased applications
• Plain ends accept solvent-weld cement compatible with PVC conduit systems
• PVC construction provides corrosion resistance and UV-stable performance in appropriate-rated installations

Compatibility

Designed as an OEM-style fitting for use with 5-inch trade size Schedule 40 PVC electrical conduit systems installed per NEC requirements.

Installation Notes

Installation is performed by licensed electricians in accordance with the National Electrical Code (NEC) and applicable local codes. De-energize all circuits and verify the conduit run is clear before pulling conductors. Use approved PVC conduit primer and cement when making solvent-weld joints; allow full cure time per the cement manufacturer instructions before handling or backfilling. Do not use open flame or heat guns to adjust PVC fittings on Schedule 40 material.

Technical Specifications

• Trade Size: 5 inches
• Bend Angle: 45 degrees
• Bend Radius: 24 inches
• Type: Standard Radius
• Schedule: 40
• End Type: Plain End
• Material: PVC
• UPC: 98006006072

Standard Information

• Brand: IPEX
• Manufacturer Part Number: 500p4045dsch40elb