Ipex 300p4045dsch40elb Pvc Sch 40 3 Inch 45 Degree Elbow

Product Description

The IPEX 300p4045dsch40elb is a 3-inch Schedule 40 PVC conduit 45-degree elbow with plain ends, designed for use in electrical conduit systems. This standard-radius elbow provides a smooth directional change in conduit runs, reducing stress on wire and cable during pull-through. Constructed from rigid PVC with a 13-inch bend radius, it suits both above-ground and below-grade installations where corrosion resistance and cost-effective performance are priorities. Electricians and electrical contractors install this fitting as part of EMT and rigid PVC raceway systems in residential and commercial construction.

This elbow is suited for use in electrical conduit installations requiring a 45-degree change of direction in a 3-inch conduit run. It is commonly used in commercial buildings, industrial facilities, and residential construction where PVC conduit systems are specified. The plain-end design allows for solvent-cement connections, making it compatible with standard PVC conduit installation practices. It is appropriate for direct burial, concrete encasement, and exposed installations per applicable electrical codes.

Key Features

• 3-inch trade size fits standard Schedule 40 PVC conduit systems
• 45-degree bend angle for gradual directional changes in conduit runs
• 13-inch bend radius reduces pulling tension on conductors
• Standard-radius construction per recognized conduit fitting classifications
• Plain-end design accepts solvent-cement connections for secure, watertight joints
• PVC material offers corrosion resistance for direct burial and exposed use

Compatibility

Designed as an OEM-style replacement and standard fitting for 3-inch Schedule 40 PVC electrical conduit systems installed per NEC requirements.

Installation Notes

Installation should be performed by a licensed electrician in accordance with NFPA 70 (NEC) and local electrical codes. De-energize all circuits and verify the conduit run is free of pull tension before cutting or joining fittings. Use approved PVC solvent cement and primer on plain ends, and allow adequate cure time before pulling conductors. Do not exceed the maximum conductor fill or bend count specified for the conduit run per NEC Chapter 9 tables.

Technical Specifications

• Trade Size: 3 inches
• Material: PVC
• Schedule: Schedule 40
• Bend Angle: 45 degrees
• Bend Radius: 13 inches
• Radius Type: Standard Radius
• End Type: Plain End

Standard Information

• Brand: IPEX
• Manufacturer Part Number: 300p4045dsch40elb