Icc ICCMSJHB44 J-hook Beam Clamp 2 Inch 25-pack

Product Description

The ICC - INT'L CONNECTORS CABLE ICCMSJHB44 is a 2-inch J-hook with integrated beam clamp, sold in a 25-pack for efficient jobsite stocking. This cable support hardware is designed to route and support low-voltage cabling - including Cat5e, Cat6, coax, and fiber runs - without crushing or kinking the cable jacket. The beam clamp attachment allows the hook to fasten directly to structural steel beams or bar joists, eliminating the need for drilling or additional fasteners. It is a standard component in structured cabling installations for commercial and light industrial environments.

This product is used in commercial, institutional, and light industrial cable pathway installations. Installers route horizontal cable runs through the J-hooks, maintaining proper bend radius and separation from power circuits. The beam clamp mounting makes these hooks well suited for open-ceiling environments such as office build-outs, data centers, warehouses, and school facilities where exposed structural steel is the primary mounting surface.

Key Features

• 2-inch inside diameter J-hook supports multiple low-voltage cable bundles
• Integrated beam clamp attaches directly to structural steel without drilling
• 25-pack quantity reduces trip counts and speeds installation on large runs
• Sold per pack, suitable for stocking service vehicles and project staging
• Appropriate for Cat5e, Cat6, coax, and similar low-voltage cabling applications

Compatibility

Designed as a standard low-voltage cable support accessory for use in structured cabling pathways in commercial and light industrial installations. No specific model compatibility data was provided by the manufacturer for this listing.

Installation Notes

Installation is typically performed by licensed low-voltage or data/communications cabling technicians in accordance with BICSI standards and applicable local codes. Before installation, verify the load capacity of the structural member to which the beam clamp will be attached. Do not over-bundle cables in a single hook in a way that exceeds recommended fill ratios or violates bend radius requirements for the cable type being routed. Ensure cables remain separated from electrical conduit and power wiring per NEC Article 800 requirements.