Hunter 44008830 Globe Flow Control Valve 1 Inch

Product Description

The HUNTER 44008830 is a 1-inch globe-style flow control valve designed for landscape irrigation systems in residential and light commercial applications. Built from high-grade PVC with a rugged diaphragm construction, this valve provides reliable on/off control and adjustable flow management at the zone level. The globe body configuration with female thread connections suits standard lateral line installations where a technician needs precise flow balancing across multiple zones. Licensed irrigators and landscape contractors are the primary installers of this valve.

This valve is well suited for smaller landscape irrigation layouts requiring dependable zone control. The PGV series is available in angle, globe, male x male, and male x barb configurations, giving contractors flexibility across different piping layouts. Each configuration is offered in flow control and non-flow control versions. For larger sites, the PGV series also scales to 1.5-inch and 2-inch globe and angle body sizes with flow control included.

Key Features

• Globe valve body configuration for straightforward in-line installation
• Integrated flow control for zone-by-zone flow balancing
• High-grade PVC construction for corrosion resistance in buried and exposed applications
• Rugged diaphragm with reinforced support to resist stress failure under cyclic pressure
• Female thread connections on both ports for compatibility with standard threaded fittings
• Suited for residential and light commercial irrigation demands

Compatibility

Designed as an OEM-style replacement or new-installation globe flow control valve for residential and light commercial landscape irrigation systems using 1-inch threaded pipe connections.

Installation Notes

Installation is performed by licensed irrigation technicians or qualified landscape contractors. Shut off the irrigation mainline and relieve system pressure before disassembling any existing valve or fitting. Use thread sealant tape on all threaded connections and avoid over-tightening PVC fittings to prevent cracking. Wire connections to the solenoid should be made per local code and the controller manufacturer wiring diagram.