Hunter 44007520 Sensor Receptacle Tee Sch 40 2 Inch

Product Description

The HUNTER 44007520 is a Schedule 40 sensor receptacle tee fitting designed for integration with flow-sensing systems in irrigation applications. Configured with slip x slip connections in a 2-inch size, this tee provides a dedicated port for installing a flow sensor directly into the irrigation mainline. It is a core component of the Hunter Flow-Sync system, enabling accurate measurement of actual water flow conditions. Licensed irrigation technicians and landscape contractors install this fitting during system commissioning or upgrades to add flow monitoring capability to an existing pipeline.

This tee is used in residential and commercial irrigation systems where flow monitoring and automatic response to abnormal flow conditions are required. It is designed for use on pipe sizes up to 4 inches and connects directly with the Hunter ACC and I-Core controllers when paired with the appropriate Flow-Sync sensor. A typical installation involves splicing this tee into the irrigation mainline upstream of zone valves, ideally in conjunction with a master valve to enable automatic shutoff during high or low flow events caused by line breaks or other failures.

Key Features

• Schedule 40 construction for compatibility with standard irrigation mainline piping
• Slip x slip end connections for solvent-welded PVC installation
• 2-inch pipe size fits common residential and commercial mainline configurations
• Dedicated sensor port accepts Hunter Flow-Sync sensor for inline flow measurement
• Supports automatic detection of high and low flow conditions when used with compatible controllers
• Designed for use on pipe sizes up to 4 inches within the Flow-Sync system

Compatibility

Designed for use with the Hunter Flow-Sync system and compatible with Hunter ACC and I-Core irrigation controllers for flow monitoring and automatic flow-event response.

Installation Notes

Installation is performed by licensed irrigation technicians or qualified landscape contractors. Shut off the mainline water supply and relieve system pressure before cutting into the pipe. Solvent-weld the slip connections using PVC primer and cement rated for the pipe schedule and service conditions, following local plumbing codes. Allow full cure time before pressurizing the system and verifying sensor operation through the connected controller.