Hubbell Wiring Device-kellems HBL6MPS Power Outlet Strip

Product Description

The HUBBELL WIRING DEVICE-KELLEMS HBL6MPS is a 6-outlet power outlet strip rated for 15 amps at 125 volts. Built with a metal housing in an office white finish, it provides a single-circuit distribution point for standard NEMA 5-15R receptacles. The strip measures 12.25 inches in length and mounts via direct plug-in connection, making it a practical addition to industrial workstations, test benches, equipment racks, and commercial service environments. Electricians and facility maintenance technicians typically install this strip where multiple low-amperage devices need a shared, code-compliant power source without requiring permanent hardwiring.

The HBL6MPS is suited for industrial and commercial settings where a reliable, UL Listed outlet strip is required. Its 6-foot cord provides reach from a wall receptacle to the point of use, and the manual trip reset on the built-in circuit protection allows quick restoration after a trip event. This strip is appropriate for powering test equipment, power tools, computers, and similar loads in light industrial or office environments where a NEMA 5-15R configuration is standard.

Key Features

• 6 NEMA 5-15R outlets on a single 15-amp, 125-volt circuit
• Metal construction for durability in industrial and commercial environments
• 6-foot cord with direct plug-in mounting — no additional hardware required
• Manual trip reset for quick circuit restoration after overload
• UL Listed for compliance with applicable electrical safety standards
• Compact 12.25-inch strip length fits standard workbench and rack installations

Compatibility

Designed for use with standard NEMA 5-15P wall receptacles in industrial and commercial electrical installations requiring 125-volt, 15-amp service.

Installation Notes

Installation should be performed by a qualified electrician in accordance with the National Electrical Code (NEC) and applicable local codes. Power down the source receptacle before connecting or disconnecting the strip. Do not exceed the 15-amp circuit rating by daisy-chaining multiple strips or connecting high-draw equipment. Verify that the wall receptacle supplying the strip is properly grounded and rated for the intended load.