Hubbell Wiring Device-kellems 073041279 Cable Support Grip

Product Description

The HUBBELL WIRING DEVICE-KELLEMS 073041279 is a single loop support grip designed to support and suspend cables during installation and long-term service. Constructed from galvanized steel mesh, this grip accommodates cable diameters from 0.56 to 0.73 inches and delivers a breaking strength of 1,000 pounds. The overall length is 13 inches, with a 6-inch mesh section that wraps and holds the cable securely. Licensed electricians and cable installation crews use this type of grip to relieve mechanical stress at termination points and anchor cable runs in conduit, tray, or vertical riser applications.

This support grip is suited for residential and commercial electrical installations where cables must be suspended vertically or supported along horizontal runs. The single loop design allows attachment to a hook, rod, or support structure using standard rigging hardware. It is commonly used in panel feeders, service entrance cable runs, and in-conduit vertical drops where cable weight could damage insulation or terminations over time. The galvanized steel construction resists corrosion in indoor and exposed indoor-to-outdoor transition environments.

Key Features

• Fits cable diameters from 0.56 to 0.73 inches
• 1,000-pound breaking strength for reliable load-bearing support
• Galvanized steel mesh construction for corrosion resistance
• 13-inch overall length with 6-inch mesh engagement zone
• Single loop end for easy attachment to support hardware
• CSA Certified and UL Listed per applicable standards including UL 94 HB and UL 94 V-2

Compatibility

Designed as an OEM-style replacement or new-installation support grip for cables with an outside diameter between 0.56 and 0.73 inches in electrical distribution, feeder, and riser applications.

Installation Notes

Installation is typically performed by a licensed electrician. De-energize the circuit and follow all applicable NEC requirements before handling cable or support hardware. Slide the mesh section fully over the cable end before attaching the support loop to the anchor point, ensuring the grip seats evenly around the cable jacket. Do not exceed the rated breaking strength of 1,000 pounds or use this grip as a primary structural support for loads beyond its rating.