Hubbell SHC1027ZP Straight Strain Relief Cord Grip 1/2 Npt

Product Description

The HUBBELL WIRING DEVICE-KELLEMS SHC1027ZP is a straight strain relief cord grip designed to secure and protect electrical cables where they enter conduit or enclosures. It features a 1/2-inch NPT thread for standard conduit connections and accommodates cable outer diameters from 0.5 to 0.62 inches. Constructed from zinc-plated steel, it carries an IP66 ingress protection rating, making it suitable for wet or dusty environments where a sealed cable entry point is required. The overall assembly length is 1.55 inches. Electricians and industrial maintenance technicians install this fitting to prevent cable pull-out and reduce mechanical stress on conductor terminations.

This cord grip is suited for general-duty electrical installations in commercial and industrial settings. Typical applications include panel enclosures, junction boxes, and control cabinets where a straight cable entry is required. The 1/2-inch NPT thread size is one of the most common conduit entry sizes, making this fitting a standard replacement or new-installation choice for a wide range of box knockouts and conduit hubs. The IP66 rating supports use in locations exposed to water jets or heavy dust accumulation.

Key Features

• Straight configuration for direct inline cable entry into enclosures or conduit
• Accommodates cable outer diameters from 0.5 to 0.62 inches
• 1/2-inch NPT thread for compatibility with standard conduit knockouts and hubs
• Zinc-plated steel construction for corrosion resistance in demanding environments
• IP66 ingress protection rating — sealed against dust and high-pressure water jets
• Compact 1.55-inch overall length minimizes enclosure footprint

Compatibility

Designed as a general-duty OEM-style strain relief cord grip for use with standard 1/2-inch NPT conduit entries on electrical enclosures, junction boxes, and control panels.

Installation Notes

Installation is performed by a licensed electrician following applicable NEC requirements. De-energize the circuit and lock out the panel before beginning work. Thread the fitting into the 1/2-inch NPT knockout, then route the cable through the grip and tighten the clamping mechanism to secure the cable without damaging the jacket. Do not overtighten to the point of deforming the cable outer jacket or compromising the IP66 seal.