Honeywell Commercial Security IB-200D Dual Photobeam 200 Ft

Product Description

The HONEYWELL COMMERCIAL SECURITY IB-200D is a dual photobeam detector designed for perimeter intrusion detection applications. Dual-beam technology reduces false alarms by requiring both beams to be broken simultaneously before triggering an alert. With a 200-foot detection range, this unit is suited for protecting large openings, driveways, gates, and building perimeters. Licensed security technicians and alarm system installers are the primary trade installing this device. Note that this part has been designated discontinued by the manufacturer and may have limited availability.

The IB-200D is intended for commercial and industrial perimeter security installations where long-range photobeam detection is required. Typical applications include warehouse loading areas, parking facilities, large gate entrances, and exterior building lines where a continuous detection zone spanning up to 200 feet is needed. It is designed for outdoor or covered perimeter use where a reliable dual-beam barrier is required to distinguish actual intrusions from environmental interference such as debris or small animals.

Key Features

• Dual photobeam design reduces nuisance false alarms by requiring simultaneous beam interruption
• 200-foot detection range suitable for wide perimeter openings and long corridors
• Intended for commercial and industrial security perimeter applications
• Sold as a single unit per package

Compatibility

Designed as an OEM-style replacement or direct-install unit for commercial perimeter intrusion detection systems that support photobeam barrier detectors.

Installation Notes

Installation should be performed by a licensed alarm or low-voltage security technician in accordance with local codes and the National Electrical Code (NEC) for low-voltage wiring. Power down the security panel and isolate the circuit zone before wiring the detector. Align transmitter and receiver units carefully along a clear line of sight at the same height to ensure beam continuity. Verify tamper and end-of-line resistor requirements with the control panel documentation before commissioning.