Honeywell 28-0910B/10XL Cut Resistant Gloves Ansi A9 Xl

Product Description

The HONEYWELL 28-0910B/10XL is a cut-resistant work glove rated ANSI/ISEA Cut Level A9, designed for trade and industrial applications where hand protection against sharp edges, abrasion, and puncture hazards is critical. The glove features a nitrile dipped palm coating over a seamless HPPE and Kevlar liner, delivering ANSI Abrasion Level 4 resistance and ANSI Puncture Level 4 performance. Constructed at 10-gauge material weight, it balances protection with dexterity. The palm includes reinforced zones and touchscreen-compatible areas, and the knit cuff provides a secure, comfortable fit for extended wear. Licensed contractors and field technicians across HVAC, plumbing, electrical, and general mechanical trades commonly use this glove when handling sheet metal, pipe, conduit, and other cut-hazard materials.

This glove is suited for residential and commercial trade work involving sheet metal fabrication, conduit handling, piping installation, and similar tasks where ANSI A9 cut protection is warranted. The smooth nitrile palm coating maintains grip in dry conditions. The HPPE and Kevlar back construction provides all-around protection, not just palm-side coverage. The unisex sizing runs XL for men and Large for women. The EN 388 rating of 4X44F confirms performance under European mechanical hazard standards as well, making this glove applicable on job sites requiring internationally recognized certifications. Sold as a pair.

Key Features

• ANSI/ISEA Cut Resistance Level A9 for high-hazard cutting applications
• ANSI/ISEA Abrasion Resistance Level 4 for extended durability on rough surfaces
• ANSI/ISEA Puncture Resistance Level 4 for protection against sharp points
• Nitrile dipped palm coating with reinforced zones and touchscreen palm capability
• Seamless HPPE and Kevlar liner reduces interior friction and hot spots during prolonged use
• EN 388 Rating 4X44F meets European mechanical protection standards
• 10-gauge construction balances protection with hand mobility

Compatibility

Designed as a general-purpose cut-resistant work glove for trade professionals requiring ANSI/ISEA 105 and EN 388 compliant hand protection in mechanical, construction, and industrial service environments.

Installation Notes

Inspect gloves before each use for tears, coating separation, or liner damage that could compromise protection. Replace immediately if the nitrile coating shows cracking or delamination. This glove is not rated as a chemical-resistant glove and should not be used as a barrier against hazardous liquids. Compliance with applicable site PPE requirements and OSHA 29 CFR 1910.138 personal protective equipment standards is the responsibility of the employer and qualified safety personnel.