Honeywell 21-1818B/6XS Cut-resistant Gloves Ansi A1 Xs

Product Description

The HONEYWELL 21-1818B/6XS is a cut-resistant work glove engineered for trade and industrial applications where hand protection and dexterity must coexist. Constructed from an 18-gauge nylon and HPPE blend, this glove carries an ANSI/ISEA Cut Resistance Level A1 rating and an EN 388 rating of 4X21A. The palm is dipped in smooth-grip nitrile, delivering reliable grip on dry and lightly oily surfaces without sacrificing tactile feedback. At 13.5 inches overall length, the glove provides wrist coverage through a seamless knit lining and knit cuff. It ships as a pair and suits HVAC, electrical, plumbing, and light assembly work where cut hazards are present at lower severity levels.

This glove is suited for residential and commercial trade environments where workers handle sheet metal edges, conduit, pipe fittings, or similar components with low-to-moderate cut risk. The X-Small sizing and unisex design make it appropriate for a range of hand sizes on the smaller end of the spectrum. The reinforced and touchscreen-compatible palm allows workers to interact with mobile devices and tablets on the job without removing the glove. It meets EN 420, EN 388, and ANSI 105 standards, making it appropriate for job sites that require documented hand protection compliance.

Key Features

• ANSI/ISEA Cut Resistance Level A1 and ANSI/ISEA Abrasion Resistance Level 4
• EN 388 rating 4X21A for standardized European cut and abrasion compliance
• 18-gauge nylon and HPPE construction with seamless knit lining for all-day comfort
• Nitrile palm coating with smooth grip surface for reliable tactile feedback
• Reinforced and touchscreen-compatible palm for device use without glove removal
• Knit cuff with 13.5-inch overall length for added wrist coverage

Compatibility

Designed as an OEM-style replacement and standard-issue cut-resistant glove for trade professionals requiring ANSI A1 hand protection in light cut-hazard environments.

Installation Notes

Cut-resistant gloves should be inspected before each use for tears, coating separation, or compromised seams. Replace immediately if structural integrity is in question. Gloves do not substitute for lockout/tagout procedures when working on energized or pressurized systems. Follow applicable site safety programs and OSHA hand protection requirements when selecting and issuing gloves to workers.