Hillman Fasteners 9188 Magnetic Hex Driver Screw 1/4 in 5pk

Product Description

The HILLMAN FASTENERS 9188 is a 1/4-inch magnetic hex driver screw designed for fast, secure fastening in trade and light industrial applications. The magnetic design holds the screw on the driver bit during placement, reducing dropped fasteners and improving one-handed installation efficiency. Each pack contains 5 screws, making it a practical grab-and-go quantity for service calls, panel work, or equipment assembly. This type of fastener is commonly installed by HVAC technicians, electricians, and general contractors who work with sheet metal enclosures, electrical panels, and access covers.

These hex driver screws are suited for residential and light commercial service work where quick, repeatable fastening is needed. The 1/4-inch drive size is compatible with standard magnetic hex bit drivers and nut drivers found in most trade tool kits. The 5-count single pack format is well suited for technicians who need a small, job-specific quantity rather than a bulk box. Typical install scenarios include securing HVAC cabinet panels, electrical enclosure covers, and similar sheet metal assemblies.

Key Features

• Magnetic design retains screw on driver bit for controlled, one-handed placement
• 1/4-inch hex drive size fits standard trade hex bit drivers and nut drivers
• 5-screw pack provides a compact, job-site-ready quantity
• Suited for sheet metal panel and enclosure fastening common in HVAC and electrical work

Compatibility

Designed as a standard 1/4-inch magnetic hex driver screw for use with 1/4-inch hex bit drivers and nut drivers in general trade fastening applications.

Installation Notes

Installation is performed by HVAC technicians, electricians, or general contractors using a 1/4-inch hex driver or compatible power tool. Power down and de-energize any electrical enclosure or HVAC unit before removing or replacing panel fasteners. Avoid overtightening in sheet metal applications to prevent stripping the receiving material. Follow applicable NEC or equipment manufacturer guidelines when re-securing electrical enclosure covers.