Hillman Fasteners 823320 Ss Sheet Metal Screw 12x1-1/2 100pk

Product Description

The HILLMAN FASTENERS 823320 is a No. 12 x 1-1/2 inch stainless steel sheet metal screw designed for secure fastening in metal fabrication, HVAC ductwork, electrical enclosures, and general trade applications. Each screw features a Phillips drive pan head, providing a low-profile bearing surface and reliable torque transfer with a standard Phillips bit. Stainless steel construction resists corrosion in wet, outdoor, and chemically exposed environments. This package contains 100 screws, making it a practical supply quantity for contractors and service technicians working through repetitive fastening tasks on sheet metal assemblies.

These sheet metal screws are suited for light-gauge metal panels, HVAC duct connections, electrical enclosure covers, and similar trade applications where a corrosion-resistant fastener is required. The pan head profile works well in surface-mount scenarios where a flat or countersunk head is not needed. Professionals in HVAC, electrical, and plumbing trades commonly stock this size for field service and installation work where No. 12 sheet metal screws are a recurring requirement.

Key Features

• No. 12 x 1-1/2 inch size — common trade stock size for sheet metal assembly
• Stainless steel construction for corrosion resistance in wet and outdoor environments
• Phillips pan head drive for use with standard Phillips bits
• Pan head profile provides broad bearing surface on sheet metal panels
• 100-screw pack quantity reduces reorder frequency on active job sites

Compatibility

Designed as a standard No. 12 x 1-1/2 inch Phillips pan head sheet metal screw suitable for light-gauge metal panels and enclosures typical in HVAC, electrical, and related trade installations.

Installation Notes

Sheet metal screws of this type are installed by HVAC technicians, electricians, and plumbers using a Phillips-head bit and a power driver or hand screwdriver. Pre-drilling a pilot hole in heavier gauge material is recommended to prevent material distortion and reduce cam-out. Always verify that the fastener material is compatible with the base metal to avoid galvanic corrosion when used with dissimilar metals.