Hillman Fasteners 823300 Sheet Metal Screw No.10x2 in 100pk

Product Description

The HILLMAN FASTENERS 823300 is a stainless steel sheet metal screw designed for secure fastening in metal substrates. Sized at No. 10 x 2 inches with a Phillips drive and pan head profile, this screw delivers reliable holding power in thin-gauge sheet metal, HVAC ductwork, electrical enclosures, and similar trade applications. The stainless steel construction resists corrosion in humid or outdoor environments. Each box contains 100 screws, making it a practical quantity for service vans and jobsite stock. These fasteners are commonly installed by HVAC technicians, electricians, plumbers, and general sheet metal workers.

These screws are suited for light- to medium-gauge sheet metal assembly in both residential and commercial settings. Typical applications include securing duct panels, junction box covers, equipment access panels, and sheet metal enclosures. The pan head profile provides a wide bearing surface that resists pull-through, while the Phillips drive is compatible with standard bit sets carried by most tradespeople.

Key Features

• No. 10 x 2 inch size — suitable for standard sheet metal fastening tasks
• Stainless steel construction for corrosion resistance in wet or outdoor environments
• Pan head profile provides broad bearing surface and resists pull-through
• Phillips drive compatible with common power drivers and hand tools
• 100-count pack for jobsite convenience and service vehicle stocking

Compatibility

Designed as a general-purpose sheet metal fastener suitable for light- to medium-gauge metal panels, duct assemblies, and enclosures where a No. 10 x 2 inch stainless pan head screw is specified.

Installation Notes

Sheet metal screws of this type are installed by HVAC technicians, electricians, and sheet metal workers using a Phillips bit in a power driver or manual screwdriver. Pilot holes are recommended in heavier gauge stock to prevent material distortion and reduce driver cam-out. Follow applicable codes such as the IFGC or NEC when fastening panels on gas or electrical equipment. Avoid over-torquing, which can strip the metal or damage the screw head.