Hillman Fasteners 80105 Sheet Metal Screw No.14 X 3/4 in 100pk

Product Description

The HILLMAN FASTENERS 80105 is a zinc-plated sheet metal screw designed for fastening into light-gauge metal panels, ductwork, housings, and similar sheet metal assemblies. Sized at No. 14 x 3/4 inches with a Phillips drive and pan head profile, this screw provides a broad bearing surface and resists cam-out during installation. Each package contains 100 screws, making it practical for jobs requiring consistent, repeatable hardware. The zinc plating offers basic corrosion resistance suitable for indoor and protected applications. HVAC technicians, electricians, and general sheet metal workers are the primary installers.

These screws are suited for light commercial and residential applications where No. 14 diameter sheet metal fasteners are specified. Common uses include securing HVAC duct sections, electrical enclosure panels, metal junction boxes, and equipment covers. The pan head style keeps the fastener profile low against the work surface, which is useful in confined equipment spaces and panel interiors. The Phillips recess is compatible with standard No. 2 Phillips bits used throughout the trade.

Key Features

• No. 14 x 3/4 inch size for light-gauge sheet metal fastening
• Phillips drive pan head for broad bearing surface and low-profile seating
• Zinc plating provides corrosion resistance for indoor and protected environments
• 100-piece pack supports production-volume and service-call quantities
• Self-tapping thread form cuts into sheet metal without pre-tapping

Compatibility

Designed as an OEM-style replacement and general-use fastener for applications requiring No. 14 diameter Phillips pan head sheet metal screws in light-gauge metal assemblies.

Installation Notes

Sheet metal screws are installed by licensed HVAC technicians, electricians, and sheet metal workers following applicable codes such as SMACNA standards and the NEC where electrical enclosures are involved. De-energize and lock out all equipment before fastening near electrical components. Use a No. 2 Phillips bit at controlled torque to avoid stripping the recess or pulling through thin-gauge material. Do not reuse sheet metal screws in the same pilot hole, as thread engagement will be compromised.