Hillman Fasteners 80048 Sheet Metal Screw 8x1 in 100pk

Product Description

The HILLMAN FASTENERS 80048 is a No. 8 x 1 inch zinc-plated sheet metal screw with a Phillips drive and pan head profile. Designed for fastening thin metal panels, brackets, ductwork, and electrical enclosures, this screw threads directly into pre-drilled or self-tapping sheet metal applications. The zinc plating provides basic corrosion resistance for indoor and sheltered installations. Sold in a 100-count pack, the 80048 is a working-quantity supply suited for service vans and job-site bins where consistent fastener availability matters.

This screw is appropriate for light-gauge sheet metal work encountered across HVAC, electrical, plumbing, and general construction trades. Typical applications include securing duct collars and access panels, mounting electrical junction box covers, attaching metal brackets to framing, and general sheet metal assembly. The pan head delivers a wide bearing surface without the profile of a hex head, making it well suited to flush or near-flush installations where clearance is limited.

Key Features

• No. 8 x 1 inch size fits a wide range of light-gauge sheet metal fastening tasks
• Phillips drive compatible with standard No. 2 Phillips bits and drivers
• Pan head profile provides broad clamping surface without raised hex flange
• Zinc plating offers corrosion resistance for indoor and sheltered environments
• 100-count pack supports volume work and van-stock replenishment

Compatibility

Designed as a standard No. 8 x 1 inch pan head sheet metal screw suitable for light-gauge metal substrates commonly found in HVAC ductwork, electrical enclosures, and general metal fabrication applications.

Installation Notes

Sheet metal screws of this type are installed by electricians, HVAC technicians, and general tradespeople using a No. 2 Phillips bit in a drill-driver or screw gun. Always confirm the substrate gauge and pre-drill or use a self-tapping pilot where required to avoid material distortion. De-energize any electrical enclosure before fastening covers or panels. Do not overdrive — pan head screws in thin metal will strip or deform the substrate if torque is not controlled.