Hillman Fasteners 47314 Trim Screw 2.25in No.6 Box of 12

Product Description

The HILLMAN FASTENERS 47314 is a black phosphate coated trim screw designed for finish carpentry and interior trim applications. At 2.25 inches in length and sized No. 6, this screw features a sharp point tip, fine thread pattern, and square drive recess. The black phosphate finish provides a low-sheen appearance that blends with dark trim materials and offers basic corrosion resistance during installation. Sold in a box of 12, this fastener is suited for carpenters, finish contractors, and trim installers who need a reliable, consistent screw for molding, casing, and interior millwork work.

These trim screws are intended for interior finish work where a clean, countersunk fastener is required. The fine thread is well suited for hardwoods and composite trim materials where thread engagement and holding strength are important. The square drive reduces cam-out during installation, keeping bit engagement consistent across repeated driving. Typical applications include door and window casing, base molding, crown molding, chair rail, and similar interior trim installations.

Key Features

• Black phosphate finish for low-sheen appearance and basic corrosion resistance
• Sharp point tip for clean entry without pre-drilling in most trim stock
• Square drive recess reduces cam-out during installation
• Fine thread pattern for strong engagement in hardwood and composite trim
• No. 6 diameter at 2.25 inches length suits standard interior trim thickness
• Sold in a box of 12 for job-site convenience

Compatibility

Designed as a general-purpose interior trim fastener compatible with standard square drive bits; suitable for use in hardwood, softwood, and composite interior trim and molding applications.

Installation Notes

Trim screws are typically installed by finish carpenters using a drill-driver set to a controlled clutch depth to avoid overdriving into trim stock. Use the appropriate square drive bit size to maintain full contact with the drive recess throughout the fastening cycle. Pre-drilling a pilot hole is recommended in hardwood trim to prevent splitting near edges or ends. Follow all applicable building codes for finish carpentry fastening in your jurisdiction.