Hillman Fasteners 47283 Lath Screw 1.5in X 8 Zinc Box 12

Product Description

The HILLMAN FASTENERS 47283 is a zinc-plated truss head lath screw designed for securing metal lath in plastering and stucco applications. The self-piercing point drives through metal lath without pre-drilling, reducing installation time on the job. The low-profile truss head spreads load across the lath surface for a secure hold. Each box contains 12 screws at 1.5 inches in length with a number 8 shank diameter. Plasters, stucco applicators, and general contractors rely on this fastener for both residential and light commercial work.

This screw is suited for attaching metal lath to wood or light-gauge steel framing before plaster or stucco coats are applied. It is commonly used in interior and exterior wall assemblies where a flush, stable lath base is required. The zinc finish provides basic corrosion resistance appropriate for protected and semi-exposed environments. Sold by the box, it is a standard stocking item for plastering crews and trim-out contractors.

Key Features

• Self-piercing point eliminates the need for pre-drilling through metal lath
• Truss head profile distributes clamping load evenly across lath wire
• Zinc plating provides corrosion resistance for interior and protected exterior use
• Number 8 shank diameter provides solid holding strength in wood and light-gauge steel framing
• 1.5-inch length suited to standard metal lath thickness over wood or steel substrates
• Packaged 12 screws per box for easy jobsite distribution

Compatibility

Designed as a standard replacement or stocking fastener for metal lath installation in residential and light commercial plastering and stucco assemblies.

Installation Notes

Installation is performed by plastering contractors or general carpenters following applicable building code requirements for lath and plaster assemblies. Drive screws with a screw gun or drill-driver set to appropriate clutch depth to avoid overdriving through the lath wire. Ensure framing members are plumb and properly spaced before fastening lath. Do not use in direct water-immersion or high-chloride environments where corrosion resistance beyond standard zinc plating is required.