Hillman Fasteners 41595 Trim Head Screw 6x1-5/8 in 25-pack

Product Description

The HILLMAN FASTENERS 41595 is a trim head screw designed for applications where a low-profile fastener head is required. Each screw measures No. 6 in diameter by 1-5/8 inches in length and features a fine thread pitch for secure engagement in hardwood, composite materials, and other dense substrates. The screw body is phosphated hardened steel, which provides corrosion resistance and surface hardness suited for interior finish work. Drive interface is a No. 1 Phillips recess. This fastener is installed by carpenters, finish contractors, and general tradespeople working on trim, millwork, and similar finish applications.

This 25-pack of trim head screws is suited for residential and light commercial finish carpentry. The trim head design leaves a smaller surface footprint than a standard bugle or flat head, making it appropriate for door casing, baseboard, crown molding, and other visible trim installations where a minimal fastener profile is preferred. The fine thread pattern provides consistent pull-down force in engineered wood and hardwood without splitting thin stock.

Key Features

• Trim head profile leaves a low-visibility footprint on finish surfaces
• Fine thread for secure engagement in hardwood and dense composite substrates
• Phosphated hardened steel construction for surface hardness and corrosion resistance
• No. 1 Phillips recess for standard driver compatibility
• No. 6 x 1-5/8 inches sizing suitable for typical trim and millwork thickness
• 25-pack quantity for small-batch finish work and repair tasks

Compatibility

Designed as an OEM-style trim head fastener for use in residential and light commercial finish carpentry applications involving wood, engineered wood, and composite trim materials.

Installation Notes

Installation is performed by carpenters and finish contractors using a No. 1 Phillips driver bit, either manual or power-assisted at low torque to avoid overdriving the trim head. Pre-drilling a pilot hole is recommended in hardwood to prevent splitting, especially near board ends. Follow applicable building codes for fastener spacing on structural trim assemblies.