Hillman Fasteners 40141 Wood Screw 10x3 Zinc 100 Pack

Product Description

The HILLMAN FASTENERS 40141 is a flat head Phillips drive wood screw designed for structural and finish wood fastening applications. Offered in a 100-count pack, each screw measures No. 10 diameter by 3 inches in length and features a flat head profile that sits flush with or below the material surface when countersunk. The zinc coating provides basic corrosion resistance suitable for interior and protected exterior applications. These screws are a staple fastener for carpenters, finish contractors, and general trades workers who need a reliable, consistent wood screw in volume quantity.

These screws are suited for residential and light commercial woodworking, framing, cabinetry, and general wood-to-wood fastening tasks. The No. 10 x 3-inch size is commonly used when longer bite and holding strength are needed through dimensional lumber or thick stock. The Phillips drive is compatible with standard power drivers and hand screwdrivers, making them practical for jobsite use. The 100-count packaging is appropriate for contractors or service technicians who use this size regularly and want consistent inventory on hand.

Key Features

• No. 10 x 3-inch flat head Phillips drive configuration for flush or countersunk installation
• Zinc coating for basic corrosion resistance in interior and protected exterior environments
• Flat head profile designed to sit flush with the wood surface when properly countersunk
• Phillips drive is compatible with standard No. 2 Phillips bits and drivers
• 100-count pack for jobsite volume use

Compatibility

Designed as a standard No. 10 x 3-inch flat head Phillips wood screw suitable for general wood fastening applications including dimensional lumber, cabinetry, and wood trim work.

Installation Notes

Installation is performed by carpenters, general contractors, and trade professionals using a No. 2 Phillips bit with a power driver or hand screwdriver. Pre-drilling a pilot hole is recommended when working near board edges or in hardwood stock to prevent splitting. Countersinking is required for the flat head to seat flush with the material surface. Follow applicable building codes when using fasteners in structural applications.