Hillman Fasteners 40015 Flat Head Phillips Wood Screw

Product Description

The HILLMAN FASTENERS 40015 is a number 6 by 3/4-inch flat head Phillips wood screw sold in a 100-piece pack. The flat head countersinks flush with the work surface, and the Phillips drive allows for quick installation with standard hand or power tools. Finished in zinc for basic corrosion resistance, these screws are suited for general wood fastening tasks in residential construction, trim work, cabinetry, and light structural assemblies. Carpenters, finish contractors, and handymen keep packs of this size on hand for high-volume repetitive fastening where consistent drive and head geometry matter.

This screw is a general-purpose wood fastener appropriate for softwood and hardwood substrates in interior and light exterior applications. The number 6 diameter and 3/4-inch length make it well suited for thin stock, face frames, drawer components, trim attachment, and similar tasks where a short, fine-gauge fastener is required. The zinc coating provides adequate protection for dry indoor environments and occasional exposure conditions. Suitable for professional trade use or volume residential projects.

Key Features

• Flat head geometry countersinks flush with or below the work surface
• Phillips drive compatible with standard 2 Phillips bits and screwdrivers
• Zinc finish provides basic corrosion resistance for general indoor use
• Number 6 diameter by 3/4-inch length suits thin stock and finish carpentry applications
• 100-piece pack quantity supports production and repetitive fastening tasks

Compatibility

Designed as a general-purpose flat head Phillips wood screw suitable for standard wood fastening applications where a number 6 by 3/4-inch zinc-coated fastener is specified.

Installation Notes

Carpenters and finish contractors install these screws using a Phillips 2 bit in a hand driver or variable-speed drill. Pre-drilling a pilot hole is recommended in hardwoods or near board edges to prevent splitting. Countersink the fastener flush to avoid surface tearout on finish-grade material. Do not overdrive with high-torque impact drivers, as the number 6 shank is susceptible to shear in that application.