Hillman Fasteners 373500 201-piece Plastic Anchor Kit

Product Description

The HILLMAN FASTENERS 373500 is a 201-piece conical plastic anchor kit designed for securing fasteners into masonry, concrete, brick, and drywall substrates. The kit includes 100 conical blue plastic anchors sized 6-8 x 0.75 inches, 100 Phillips pan head screws sized 6 x 1 inches in steel with zinc plating, and one 3/16-inch carbide-tipped masonry drill bit. This all-in-one package gives HVAC techs, plumbers, electricians, and general contractors the hardware needed to mount brackets, straps, and light fixtures directly to hard surfaces without sourcing components separately.

This kit is suited for light-duty residential and commercial mounting applications where anchoring into masonry or concrete is required. Typical uses include mounting conduit straps, pipe hangers, electrical enclosures, junction boxes, and similar hardware to block, brick, or poured concrete walls. The included carbide masonry bit is sized to match the conical anchors, allowing the installer to drill, set, and fasten in a single workflow without additional hardware.

Key Features

• 201-piece kit includes anchors, screws, and a matching masonry drill bit for a complete fastening solution
• Conical blue plastic anchors sized 6-8 x 0.75 inches for secure expansion in masonry substrates
• 100 Phillips pan head screws, 6 x 1 inches, steel construction with zinc plating for corrosion resistance
• 3/16-inch carbide-tipped masonry drill bit matched to anchor diameter
• Single kit supports up to 100 anchor-and-screw installations

Compatibility

Designed as a general-purpose conical plastic anchor kit for light-duty fastening applications in masonry, concrete, and brick substrates common in residential and commercial construction.

Installation Notes

Installation is typically performed by electricians, plumbers, HVAC technicians, or general contractors working on masonry or concrete surfaces. Ensure power is disconnected from any adjacent electrical systems before drilling near wiring. Use the included carbide masonry bit at low-to-medium drill speed with a hammer drill for best results in hard substrates. Follow applicable local building codes for fastener load ratings when mounting structural or load-bearing hardware.