Hertel 71206338 Jobber Drill Bit Wire 16 0.1770 Hss Oxide

Product Description

The HERTEL 71206338 is a jobber-length drill bit in wire gauge size 16, with a decimal diameter of 0.1770 inches. Built from high speed steel with an oxide coating, it is designed for general-purpose drilling in metal, wood, and similar materials. The 118-degree standard point angle is a widely used geometry suited to a broad range of workpiece materials. With a straight-cylindrical shank and spiral flute design, this bit fits standard drill chucks and delivers consistent chip evacuation during through-hole and blind-hole operations. HVAC technicians, plumbers, electricians, and general tradespeople keep wire-gauge drill bits like this on hand for sheet metal, brackets, and structural penetrations.

This bit is intended for general-purpose trade applications where a wire-size 16 hole is required. Common uses include drilling pilot holes, clearance holes, and access penetrations in light-gauge steel, aluminum, plastic, and wood. The 3-3/8 inch overall length and 2-3/16 inch flute length suit typical hand drill and drill press setups. The oxide finish provides a measure of surface hardness and helps reduce friction during the cut. Right-hand cutting direction is standard for conventional drill and driver tools.

Key Features

• Wire gauge size 16, 0.1770-inch decimal diameter for precise hole sizing
• High speed steel construction with oxide coating for durability and reduced friction
• 118-degree standard point angle for general-purpose material compatibility
• Right-hand spiral flute promotes efficient chip removal
• Straight-cylindrical shank fits standard 3-jaw drill chucks
• Web-thinned tapered web configuration reduces thrust and improves penetration

Compatibility

Designed as a general-purpose jobber-length drill bit for use in standard drill chucks accepting a 0.1770-inch straight-cylindrical shank, suitable for hand drills and drill presses across trade and light industrial applications.

Installation Notes

This bit is installed by a licensed tradesperson or qualified operator using a compatible hand drill or drill press. Secure the workpiece before drilling and use appropriate personal protective equipment including eye protection. Ensure the drill chuck is fully tightened around the shank before operation. Follow applicable workplace safety codes and tool manufacturer guidelines for speed selection based on material type.