Hartline Prod Co Inc 10006 Hydraulic Anchoring Cement 5 Lb

Product Description

The HARTLINE PROD CO INC 10006 is a hydraulic-type anchoring cement compound sold in a 5-pound box format. Mixed with water, it pours smoothly into gaps and voids, then sets in approximately 15 minutes without shrinking. Within one hour of placement, it develops a compressive strength of 4,500 pounds per square inch, creating a permanent mechanical bond to both metal and concrete substrates. This product is used by tradespeople who need a fast-setting, high-strength cement for anchoring hardware into masonry or concrete structures.

This anchoring cement is suited for residential and commercial applications where threaded or unthreaded fasteners must be permanently set into concrete, block, or masonry. Typical use cases include anchoring bolts, posts, screws, hooks, railings, rods, signs, poles, racks, pulleys, and motor mounts. Its hydraulic formulation makes it appropriate for both dry and damp substrate conditions. Plumbers, electricians, HVAC technicians, and general contractors working around concrete structures will find this compound applicable to a wide range of anchoring tasks.

Key Features

• Sets in approximately 15 minutes after mixing with water
• Reaches 4,500 psi compressive strength within one hour
• Non-shrink formulation maintains tight contact with substrate
• Bonds permanently to both metal and concrete surfaces
• Hydraulic cement compound suitable for anchoring a wide range of hardware types
• Pours smoothly for easy placement into holes and voids

Compatibility

Designed for use with bolts, posts, screws, hooks, bowls, washers, railings, rods, signs, pulleys, racks, poles, seats, and motors anchored into concrete or masonry substrates.

Installation Notes

This product is typically installed by licensed plumbers, electricians, HVAC technicians, or general contractors working on concrete or masonry anchoring tasks. Clean and dampen the substrate hole before mixing and pouring. Mix only the quantity needed immediately before use, as the 15-minute set time leaves little working window. Allow full cure before applying load to anchored hardware.