Guhring 9055100094000 Carbide Drill Bit 0.3701 in

Product Description

The GUHRING 9055100094000 is a solid carbide, screw machine length drill bit designed for high-performance metal drilling applications. With a 0.3701-inch (9.40 mm) diameter and a 140-degree split point (SU type), this bit delivers fast, accurate entry with minimal walking on hard materials. The coated finish extends tool life under demanding cycle conditions. Web-thinned geometry reduces thrust load, making it well suited for production drilling environments where feed rates and tool longevity are both critical. A licensed machinist or toolroom technician is the typical end user.

This drill bit is built for drilling cast iron and steel in screw machine, CNC, and production drilling setups. The straight-cylindrical shank (10.00 mm diameter) fits standard drill chucks and collet systems. Coolant-through capability supports high-speed cutting by delivering fluid directly to the cutting edge, reducing heat and chip packing in deeper holes. The 3xD flute-by-diameter ratio and 47.00 mm flute length accommodate clean chip evacuation in holes up to 44.00 mm deep. Series 5510 is Guhring's high-performance carbide stub drill line manufactured to DIN 6537 K standards.

Key Features

• Solid carbide construction with submicron grain for hardness and wear resistance
• 140-degree SU split point with web-thinned, parallel web geometry for reduced thrust and accurate entry
• Coolant-through design delivers cutting fluid directly to the drill tip
• Coated finish extends service life in abrasive ferrous materials
• Right-hand cut, 2-flute spiral configuration for effective chip evacuation
• Manufactured to DIN 6537 K specification for consistent dimensional tolerances

Compatibility

Designed as a screw machine length replacement or production drill for applications in cast iron and steel. Fits any machine spindle or chuck accepting a 10.00 mm straight-cylindrical shank.

Installation Notes

Installation and setup should be performed by a qualified machinist or toolroom professional. Ensure the machine spindle is fully stopped and locked out before changing tooling. Confirm the shank is fully seated and clamped within the chuck or collet before operation. Coolant-through systems should be verified for pressure compatibility before running at full feed and speed.