Guhring 9036800050000 Square End Mill 3 Flute Solid Carbide

Product Description

The GUHRING 9036800050000 is a solid carbide square end mill designed for precision milling in demanding industrial and toolroom applications. It features a 0.1969 inch (5.00 mm) cutting diameter, a 1.1811 inch (30.00 mm) length of cut, and a 3-flute spiral geometry with a 30-degree helix angle. The FIREX coating provides enhanced heat and wear resistance, extending tool life in ferrous and non-ferrous materials. Designated as an extra-long length type, it is well suited for reaching into deep pockets, slots, and cavities where standard-length end mills cannot reach. This end mill is installed and operated by CNC machinists and toolroom professionals.

This end mill is intended for use on CNC machining centers and manual mills handling a range of workpiece materials. The primary workpiece material codes include K (cast iron), M (stainless steel), N (non-ferrous), and P (steel). Secondary suitability extends to S (superalloys and high-temperature materials). The single-end, right-hand cut and right-hand flute configuration is standard for conventional CNC spindle applications. The straight-cylindrical shank with an h6 tolerance fits standard collet chucks and end mill holders in typical tooling setups.

Key Features

• Solid carbide construction for rigidity and dimensional accuracy in high-speed applications
• FIREX coating improves heat resistance and extends tool life across ferrous and non-ferrous workpieces
• 30-degree helix angle with 3 spiral flutes for efficient chip evacuation
• Extra-long length type with 1.1811 inch length of cut for deep pocket and slot milling
• Center-cutting geometry allows plunge entry without pre-drilling
• Straight-cylindrical shank with h6 tolerance for secure, precise collet or end mill holder fitment

Compatibility

Designed as a Series 3680 solid carbide square end mill compatible with standard collet chucks and end mill holders accepting a 0.1969 inch (5.00 mm) straight-cylindrical shank. Suited for machining cast iron, stainless steel, non-ferrous alloys, steel, and superalloys as indicated by workpiece material codes K, M, N, P, and S.

Installation Notes

This tool should be installed by a qualified machinist following the machine tool manufacturer guidelines for tool holding and runout tolerances. Ensure the spindle and machine are fully stopped and locked out before inserting or removing the end mill from the holder. Use the appropriate collet or end mill holder sized for a 0.1969 inch shank and torque the retention hardware to the holder manufacturer specification. Verify tool runout after installation before engaging the workpiece to prevent premature tool wear or breakage.