Greenlee LS100X11SS4X Hydraulic Knockout Set 18 Piece

Product Description

The GREENLEE LS100X11SS4X is an 18-piece hydraulic knockout set designed for punching clean, round holes in electrical enclosures, panels, and conduit entry points. The set uses an 11-ton Intelli-Punch hydraulic tool to drive SlugBuster Speedpunch punches and dies through material without distortion. Punch hole diameters range from 0.88 inches to 4.5445 inches, covering 1/2 inch through 3 inch plus 4 inch conduit sizes. Maximum material capacity is 10 gauge for both stainless steel and mild steel. Licensed electricians and electrical contractors are the primary users of this set.

This set is built for commercial and industrial electrical work where multiple conduit entry sizes are required in a single job. It handles the full range of common conduit trade sizes in one kit, making it suitable for panel builds, switchgear installation, and enclosure fabrication. The included carrying case organizes all components for transport between job sites. Both 1/2 inch to 3 inch conduit punches and a 4 inch conduit punch are included, along with two draw stud sizes for versatile setup configurations.

Key Features

• 11-ton Intelli-Punch hydraulic tool drives punches with controlled, consistent force
• Round SlugBuster Speedpunch punches and dies cover 1/2 inch through 3 inch plus 4 inch conduit sizes
• Rated for 10 gauge stainless steel and 10 gauge mild steel maximum capacity
• Includes two 18V 3.0Ah lithium-ion batteries and a 120V AC charger for cordless operation
• Both 3/4 inch and 3/8 inch draw studs included for flexible material setups
• Hard carrying case keeps all 18 pieces organized and protected on the job site

Compatibility

Designed for use with standard conduit trade sizes from 1/2 inch through 3 inch plus 4 inch. Punches and dies are SlugBuster Speedpunch style compatible with the included Intelli-Punch 11-ton hydraulic tool.

Installation Notes

Installation should be performed by a licensed electrician following applicable NEC requirements. Always de-energize and lock out any panel or enclosure before punching holes. Ensure the correct draw stud size is matched to the punch and die being used. Inspect punches and dies for wear or damage before each use to maintain clean, burr-free cutouts.