Greenlee 7212SP-2-1/2D Conduit Round Die 2.5 in

Product Description

The GREENLEE 7212SP-2-1/2D is a round conduit die designed for use with the Greenlee SPEED PUNCH system. It punches a 1.95-inch hole to accommodate 2.5-inch conduit, delivering clean, accurate knockouts in electrical enclosures, panel boxes, and junction boxes. This die is the component that does the cutting work in a hydraulic or manual knockout punch setup. Electricians and electrical contractors install this die as a replacement or as part of an assembled punch set when the existing die is worn or when expanding a punch kit to cover additional conduit sizes.

This die is used in commercial and residential electrical work wherever conduit entry points need to be punched into metal enclosures or sheet metal. It is specifically engineered to pair with SPEED PUNCH system components from Greenlee. Typical applications include panelboard and switchgear installations, conduit stub-up work, and service entrance roughing where clean knockout cuts are required. It is a single replacement die and does not include a punch, draw stud, or other system components.

Key Features

• Round die profile produces clean circular knockouts sized for 2.5-inch conduit
• Punch hole diameter of 1.95 inches matches standard 2.5-inch conduit knockout sizing
• Designed exclusively for compatibility with Greenlee SPEED PUNCH system components
• Compact geometry fits within a 3.7 x 3.7 x 3.7-inch envelope for easy storage in a punch kit
• Sold as a single replacement die — direct swap when the original die is damaged or worn

Compatibility

Designed for use with Greenlee SPEED PUNCH system components. Sized for 2.5-inch conduit applications. Consult the Greenlee SPEED PUNCH system documentation to confirm compatibility with the specific punch driver or knockout set in use before ordering.

Installation Notes

Installation is performed by licensed electricians familiar with hydraulic or manual knockout punch systems. De-energize and lock out all circuits in the enclosure before beginning any knockout work. Inspect the die for chips or cracks before each use, and ensure the draw stud and punch are properly aligned to avoid die damage or out-of-round cuts. Follow applicable NEC requirements for conduit entry sizing and enclosure integrity after punching.