

Ships via freight in 1-3 business days
Manufacturer pricing rules prevent us from advertising our discount — no account or email required to see it.
This product weighs 300 lb each and will be shipped via LTL carrier. A lift gate option will be added free of charge for your convenience.
Secure Payments
Easy Returns
Expert Advice
Fast Shipping
The Goodman alzs4ba6010 is a 5-ton, single-stage split heat pump condensing unit designed for ducted residential and multi-family HVAC systems. Operating on R-32 refrigerant, it delivers a rated cooling capacity of 56,500 BTU/h and a rated heating capacity of 57,000 BTU/h at a 14.3 SEER2 efficiency rating. Powered at 208/230 volts, 1-phase, 60 Hz, the unit draws a minimum circuit amperage of 31.1 amps and requires a maximum overcurrent protection of 50 amps. A standard scroll compressor and single-speed motor form the core of its refrigeration circuit. The unit is manufactured in the United States and carries ISO certification. Licensed HVAC technicians handle installation and commissioning.
The alzs4ba6010 is suited for ducted, top-discharge outdoor installations in residential and multi-family applications. It meets DOE regional compliance requirements for all regions, making it a viable option across the continental United States. The unit is non-communicating, so it pairs with standard non-communicating air handlers and coils rather than proprietary communicating systems. Cooling operation is rated for ambient conditions between 55 degrees F and 125 degrees F. Heating operation is rated down to -20 degrees F ambient, supporting cold-climate applications. Compatible accessory references noted in product documentation include ABK-20, CSR-U-2, CSR-U-3, FSK01A, LSK02A, and OT18-60A.
The alzs4ba6010 is a non-communicating outdoor condensing unit intended for use in ducted split heat pump systems. Compatible accessory part references provided by the manufacturer include ABK-20, CSR-U-2, CSR-U-3, FSK01A, LSK02A, and OT18-60A. No additional specific indoor unit or coil model compatibility was stated in the available product data.
Installation must be performed by a licensed HVAC technician holding EPA Section 608 certification, as the unit contains R-32 refrigerant. Shut off all electrical power at the disconnect and confirm zero voltage before making any electrical or refrigerant connections. The refrigerant circuit uses a 3/8-inch liquid line and a 1-1/8-inch gas line; verify line set sizing against manufacturer guidelines before brazing. Observe all applicable local mechanical codes and NEC requirements for disconnect sizing, wire gauge, and ground connections.
Thanks for subscribing!
This email has been registered!