Goodman alxs3nn4210 Split Ac 13.4 SEER2 3.5 Ton R-32

Product Description

The Goodman alxs3nn4210 is a 3.5-ton, single-stage outdoor split air conditioner rated at 13.4 SEER2 and designed for cooling-only applications using R-32 refrigerant. It delivers a rated cooling capacity of 39,500 BTU/h with an EER2 of 11.2, making it a code-compliant option for DOE North regional installations. The unit uses a scroll compressor with a single-speed motor and top-discharge airflow configuration. It is manufactured in the United States and belongs to the ALXS3N series. Licensed HVAC technicians handle installation and commissioning of this equipment.

This condensing unit is suited for residential and light-commercial split-system installations in northern DOE compliance regions. It operates on 208/230-volt single-phase power at 60 Hz and is compatible with non-communicating air handler or furnace coil configurations. The operating range spans 55 degrees F to 115 degrees F ambient, covering typical North region cooling seasons. The factory refrigerant charge is 74 oz of R-32, with a pre-charged line length of 15 feet and a maximum line set length of 200 feet.

Key Features

• 13.4 SEER2 and 11.2 EER2 efficiency ratings meeting DOE North regional compliance
• R-32 refrigerant with a 74 oz factory charge and 0.58 lb per foot additional charge allowance
• Single-stage scroll compressor with single-speed motor for straightforward operation and servicing
• Top-discharge cabinet design measuring 29 inches wide by 29 inches deep by 35.75 inches tall
• Non-communicating control interface compatible with standard thermostat wiring
• Produced in the United States; active release status in the ALXS3N series

Compatibility

Designed for use in non-communicating split-system configurations in DOE North compliance regions. Referenced accessory and component part numbers from the manufacturer include 0130R00000S, ABK-20, ASC01A, CSR-U-1, FSK01A, LAKT01, and LSK02A. No specific air handler or coil model compatibility is stated in the available product data; consult manufacturer documentation to confirm matched indoor unit selection.

Installation Notes

Installation must be performed by a licensed HVAC technician holding the appropriate EPA Section 608 certification for R-32 refrigerant handling. Disconnect and lock out all power to the system before making any electrical or refrigerant connections. Observe the minimum circuit ampacity of 19.4 amps and maximum overcurrent protection of 30 amps when sizing disconnect and breaker equipment. Follow local mechanical and electrical codes, including NEC requirements, for outdoor unit placement, line set routing, and electrical supply.