Gibraltar SW10-1XFS-G Threaded Spring Plunger 6-32

Product Description

The GIBRALTAR SW10-1XFS-G is a short threaded spring plunger designed for use in positioning, indexing, and alignment applications across mechanical assemblies. It features a No. 6-32 thread with a 3/8-inch thread length and a maximum plunger diameter of 0.046 inches. The plunger delivers 0.5 pounds of initial end force and 3.5 pounds of final end force, providing controlled, repeatable spring tension. Both the body and nose are constructed from steel for durability in light industrial environments. This type of fastener hardware is typically installed by machinists, mechanical assemblers, and maintenance technicians working on jigs, fixtures, and precision mechanical components.

Spring plungers of this type are used in applications where a retractable, spring-loaded locating or holding point is needed within a threaded bore. The short plunger length and 1/16-inch projection make this part suited for tight-clearance assemblies where minimal protrusion is required. Typical applications include fixture alignment, detent mechanisms, and light-duty part retention in machined components. This plunger is sold individually in single-unit packaging.

Key Features

• No. 6-32 thread size with 3/8-inch thread length for secure installation in tapped bores
• Short plunger length with 1/16-inch projection for tight-clearance assemblies
• 0.5-pound initial end force and 3.5-pound final end force for controlled spring tension
• Steel body and steel nose construction for mechanical durability
• No locking element — installs and removes with standard hex or screwdriver tooling
• Single-unit packaging with no minimum order quantity above one

Compatibility

Designed as an OEM-style replacement or new-installation spring plunger for mechanical assemblies, jigs, and fixtures requiring a No. 6-32 threaded spring plunger with a short body profile.

Installation Notes

Installation is performed by machinists or mechanical assemblers using standard hand tools into a properly tapped No. 6-32 threaded bore. Ensure the mating bore is clean and free of debris before threading in the plunger. Do not overtighten, as this can damage the spring mechanism or deform the plunger body. No locking element is present, so thread-locking compound may be applied at the installer's discretion based on application vibration requirements.