Gibraltar P12436GB Lifting Eye Bolt 1300 Lb 3/8-16 Thread

Product Description

The GIBRALTAR P12436GB is a without-shoulder lifting eye bolt designed for overhead lifting, rigging, and load-securing applications in industrial and commercial environments. Rated at 1,300 lb lifting capacity, it features a 3/8-16 thread and is partially threaded along a 2.5-inch thread length on a 6-inch shank. Manufactured from C-1030/C-1035 grade steel, this eye bolt is suited for use where a clean straight-pull load path is required. Rigging professionals, millwrights, and maintenance trades install this type of hardware when attaching lifting points to machinery, structural members, or fabricated assemblies.

This eye bolt is appropriate for straight vertical lifts in light industrial, mechanical, and maintenance settings. The without-shoulder design means it is not rated for angular loading and should only be used for in-line, axial pulls. The partially threaded shank allows secure engagement into tapped holes or with a nut on through-bolted applications. At 0.35 pounds, the P12436GB is a compact, single-piece lifting anchor suitable for repetitive service in plant maintenance, equipment rigging, and general trade work.

Key Features

• 1,300 lb lifting capacity for light-duty overhead rigging and load attachment
• Without-shoulder design — intended for straight axial pulls only, not angular loading
• 3/8-16 thread size with 2.5-inch partial thread length for solid engagement
• 6-inch shank length provides clearance for thick structural members or equipment housings
• C-1030/C-1035 grade steel construction for consistent mechanical strength
• 3/4-inch eye inside diameter and 1.5-inch eye outside diameter compatible with standard hooks and shackles

Compatibility

Designed for use in tapped 3/8-16 threaded holes or through-bolted configurations in standard inch-measurement rigging and lifting applications.

Installation Notes

Installation should be performed by qualified rigging or maintenance personnel following applicable ASME B30.26 and OSHA rigging safety standards. Always thread the eye bolt fully so the shank seats flush against the load surface before applying any load. Because this is a without-shoulder eye bolt, loading must be applied in a straight axial direction only — angular or side loading is not permitted with this design. Inspect the eye bolt and threaded engagement before each lift and replace any hardware showing signs of deformation, wear, or corrosion.