Gibraltar MT7702-G Straight Ejector Pin 6mm 250mm Steel

Product Description

The GIBRALTAR MT7702-G is a straight ejector pin used in injection mold tooling to push finished parts out of the mold cavity at the end of each cycle. Machined from steel with a nitride finish for surface hardness and wear resistance, this pin measures 6 mm in diameter with an overall length of 250 mm. The head measures 12 mm in diameter and 5 mm in height, seating flush in the ejector plate. The pin length below the head is 245 mm. Toolmakers, moldmakers, and mold maintenance technicians are the primary installers and users of this component.

This ejector pin is suited for use in plastic injection molds in both production and prototype tooling environments. It fits standard ejector plate assemblies where a 6 mm through-bore is specified. Typical applications include consumer product molds, automotive component tooling, and industrial part molds requiring precise, repeatable ejection. This pin is sold individually and is a direct replacement or spare for molds requiring a 6 mm straight ejector pin at 250 mm overall length.

Key Features

• 6 mm pin diameter for use in standard 6 mm ejector plate bores
• 250 mm overall length with 245 mm usable pin length below the head
• 12 mm head diameter and 5 mm head height for positive seating in ejector plates
• Steel construction with nitride finish for surface hardness and extended service life
• Sold as individual pin — quantity of one per package

Compatibility

Designed as a standard straight ejector pin replacement for injection mold tooling requiring a 6 mm diameter pin at 250 mm overall length. Consult mold drawings to confirm bore diameter and required pin length before ordering.

Installation Notes

Ejector pins are installed and serviced by qualified moldmakers or toolroom technicians. Before servicing an ejector assembly, ensure the mold is fully cooled, the press is locked out and tagged out per applicable safety procedures, and the ejector plate is fully retracted. Pins should be inspected for straightness and surface condition before installation — a bent or scored pin can damage the mold bore or cause flash at the parting line.