Gibraltar GIB07295 1/4-20 Stainless Steel Open Eye Bolt 10 Pack

Product Description

The GIBRALTAR GIB07295 is a wire turned open eye bolt designed for fastening, rigging, and tie-down applications across a wide range of trade and general construction uses. Manufactured from stainless steel, this eye bolt features a 1/4-20 thread size with a 1.25-inch thread length and a 1.5-inch shank length. The open eye measures 0.5 inches inner diameter and 0.9375 inches outer diameter, making it suited for attachment of hooks, cables, turnbuckles, and similar hardware. Stainless steel construction provides corrosion resistance in wet or outdoor environments. The wire turned design is a standard, economical form factor widely stocked by HVAC, plumbing, and general trade contractors for overhead hangers and equipment tie-down points.

This eye bolt is appropriate for residential and light commercial applications including equipment mounting, rope and cable attachment, overhead hanging, and similar rigging tasks. The 1/4-20 thread is a common coarse-thread size compatible with standard hex nuts and threaded rod fittings. Each unit is packaged in a quantity of 10, making this part practical for job-site stocking. Typical installers include HVAC mechanics, plumbers, and electricians routing support hardware through framing or structural members.

Key Features

• Stainless steel construction resists corrosion in wet and outdoor environments
• Wire turned open eye design for attachment of hooks, cables, and turnbuckles
• 1/4-20 coarse thread for compatibility with standard nuts and threaded rod fittings
• 1.25-inch thread length and 1.5-inch shank length for versatile fastening depth
• Open eye ID of 0.5 inches accommodates common rigging hardware
• Packaged in quantities of 10 for job-site efficiency

Compatibility

Designed as a standard 1/4-20 wire turned open eye bolt suitable for use with threaded rod, hex nuts, and compatible rigging hardware in light-duty hanging and fastening applications.

Installation Notes

Installation typically requires a drill, appropriate bit for the substrate, and a wrench or pliers to drive and seat the bolt. Always thread into a properly sized and tapped hole or pair with a standard 1/4-20 nut. Ensure the mounting substrate is rated for the load being applied. Shut down and de-energize any nearby equipment before drilling into structural members in live mechanical or electrical spaces.