Gibraltar G10-1910CS Skirted Knob 17/32 in Knob Dia

Product Description

The GIBRALTAR G10-1910CS is a skirted control knob designed for use in panel-mount and equipment control applications where a compact, low-profile knob with a defined recess is required. It features a 17/32-inch knob diameter and a 9/16-inch recess diameter, with a 3/4-inch skirt diameter that provides a clean finished appearance around the mounting cutout. The knob stands 1/2 inch high and accepts a stem hole depth of 13/32 inches. Set screw center height and set screw-to-bottom measurement are both 7/32 inches. This hardware component is typically installed by electricians, HVAC technicians, or equipment service professionals replacing worn or missing controls on panels and enclosures.

The G10-1910CS skirted knob is suited for residential and light commercial equipment panels, control boards, and instrumentation where a small-diameter pointer or indicator knob is needed. The skirted design conceals the panel cutout edge for a cleaner installation. This knob is commonly used in HVAC equipment controls, electrical enclosures, and similar trade-service applications requiring a compact knob with set-screw retention.

Key Features

• 17/32-inch knob diameter for compact panel applications
• Skirted design with 3/4-inch skirt diameter conceals panel cutout
• 9/16-inch recess diameter accommodates standard shaft configurations
• 13/32-inch stem hole depth with set screw retention at 7/32-inch center height
• Low-profile at 1/2 inch overall height
• Lightweight construction at approximately 0.088 pounds per unit

Compatibility

Designed as an OEM-style replacement or service part for equipment panels and control enclosures requiring a compact skirted knob with set-screw retention in the 17/32-inch diameter range.

Installation Notes

Installation is typically performed by an electrician or HVAC service technician. Power down or de-energize the equipment before removing or installing any panel knob or control component. Ensure the shaft diameter and depth match the knob stem hole specifications before seating the knob. Tighten the set screw with an appropriate hex key to secure the knob to the shaft without over-driving.